Best Door Tools Store

Quikpoint Mortar Gun With Drill

• Uses all standard and pre-mixed pointing mortars.
• Excellent mortar penetration. Vibrator fed auger drive assures constant mortar bead.
• Unbreakable polyurethane body and nozzle holder.
• Takes just 10 seconds to reload 1/2 gallon hopper.
• Quick clean up in less than a minute simply by flushing with water.
• Portable, weighs only 10 pounds (approximately 13 pounds loaded).
• Specially designed nozzle with 4 interchangeable steel tips (small: 3/16″ X 0.8″, medium: 1/4″ X 0.8″, large: 0.55″ X 0.66″, and special angled tip for overhead work 1/4″ x 0.8″).
• Nozzle rotates for horizontal and vertical joints.
• Quikpoint Mortar Gun is powered by a Makita 5.2 Amps drill, with heavy vinyl drill boot for dust and moisture protection.

.

Quickpoint Mortar Gun Without Drill.

• Uses all standard and pre-mixed pointing mortars.
• Excellent mortar penetration. Vibrator fed auger drive assures constant mortar bead.
• Unbreakable polyurethane body and nozzle holder.
• Takes just 10 seconds to reload 1/2 gallon hopper.
• Quick clean up in less than a minute simply by flushing with water.
• Portable, weighs only 10 pounds (approximately 13 pounds loaded).
• Specially designed nozzle with 4 interchangeable steel tips (small: 3/16″ X 0.8″, medium: 1/4″ X 0.8″, large: 0.55″ X 0.66″, and special angled tip for overhead work 1/4″ x 0.8″).
• Nozzle rotates for horizontal and vertical joints.
• Mounts any 3/8″ drill, if you are using a cordless drill must be 18Volts

.

Gibco’s MRF

Admixtures to enhance the performance of masonry mortars & cement based plaster

• Greater resistance to freeze & thaw
• Replaces lime
• Reduces water penetration
• No efflorescence
• Lower batch cost
• Reduced shrinkage
• Less storage & handling
• Avoids waste
• Less call backs
• Non-tonic, non-hazardous

Specification for the use of Gibco’s MRF

4A-Mortar

• Mixture for ASTM C270 Type “M” Mortar shall be 1 bag of Portland Cement Type I or II, 3 ounces of GIBCO’S MRF and 2 1/4 to 2 and 3/4 cubic feet of masonry sand.
• Mixture for ASTM C270 Type “S” Mortar shall be 1 bag Portland Cement Type I or II, 3 ounces of GIBCO’S MRF and 3 to 3 1/2 cubic feet of masonry sand.
• Mixture for ASTM C270 Type “N” Mortar shall be 1 bag of Portland Cement Type I or II, 3 ounces of GIBCO’S MRF and 3 to 3 1/2 cubic feet of masonry sand.
• The masonry sand shall comply with ASTM C144 specifications.

.